Backflow from irrigation systems, industrial equipment, or plumbing cross-connections can contaminate your building's potable water supply. FSI New Mexico provides certified backflow prevention assembly testing required annually by most New Mexico municipalities.
Backflow occurs when water flows in the wrong direction through your plumbing — potentially pulling contaminants, chemicals, or biological hazards into the drinking water supply. Backflow prevention assemblies are installed to stop this, but only if they are properly maintained and tested.
New Mexico municipalities and the New Mexico Environment Department require annual testing of all backflow prevention assemblies on commercial properties. Failing to test — or test on time — can result in fines, mandatory shutdowns, and liability if a contamination event occurs.
FSI New Mexico's certified testers perform full pressure testing of your assembly, complete the required paperwork, and submit the test report to your local water authority on your behalf.
Annual testing is required by most New Mexico municipalities. We handle the test report and submit it to your water authority so you stay compliant without the paperwork hassle.
A complete backflow prevention assembly test typically takes under an hour and causes only a brief, planned water interruption.
We examine the assembly for corrosion, physical damage, improper installation, or signs of tampering. Any issues are documented before testing begins.
Using calibrated test equipment, we pressure-test all check valves and relief valves to verify they open and close within required tolerances.
We complete the official test report required by your municipality, documenting all test readings, pass/fail results, and tester certification information.
We submit the completed report to your local water authority. If the assembly fails, we document what needs repair or replacement and can coordinate next steps.
Our certified testers are authorized to inspect, test, and repair all major commercial backflow prevention assemblies.
High-hazard protectant assemblies designed for locations with potential chemical or biological contamination.
Low-hazard protection commonly used on fire sprinkler lines and water main entry lines.
Often installed in commercial and large-scale residential irrigation and lawn sprinkler systems.
Specialized vacuum breakers designed to prevent water spillage during indoor operations.
Most commercial properties in Albuquerque and throughout New Mexico are required to have backflow prevention assemblies tested annually. If your property has an irrigation system, commercial kitchen connections, fire suppression system, or industrial equipment tied to the water supply, you almost certainly have a testable assembly.
Find answers to common questions about annual backflow prevention assembly testing and municipal water codes.
FSI New Mexico runs daily dispatch routes to commercial, restaurant, and industrial properties in the following cities:
